Installation Instructions - Lithonia Lighting OVFL LED 2RH Instrucciones De Instalación

FIXTURE PACKING LIST
Description
1) LED Light Fixture................................................................. 1
2) Photocontrol ........................................................................ 1
3) 1-1/4"Mounting Screw ........................................................ 1
4) Cross Bar ............................................................................ 1
5) 3/4" #8 & #6 & #10 screws* ................................................. 6
6) Wire Nuts* ........................................................................... 3
7) Rubber Plug* ....................................................................... 1
8) Lock Nut .............................................................................. 2
9) Adjustment Knob ................................................................. 2
*Contained in parts packs
Mounting Hardware Included
Silicone Sealant Required
REQUIRED TOOLS:
1. Remove fixture components and parts pack. Check to
ensure all parts are included. Note: Account for small parts and
destroy packing material, as these may be hazardous to children.
Note: Suitable for wall mount or eave mount. Not suitable for
ground mount installation. Not suitable for use with dimmers,
motion sensors or other remote devices.
Turn OFF Power at circuit breaker box.
CAUTION: Do not rely on wall switch alone to turn off power
For installation to properly installed and grounded UL listed
junction box
2. Install cross bar (4) to your junction box using two 3/4" #6 or #8
or #10 screws (5) (screw size is depending on your junction box).
See Fig. A.
CAUTION: WIRING AND FIXTURE OPERATION
Make sure power is turned off. Connect to 120V, 60Hz circuit only.
3. To Ground fixture use wire nut (6) to connect the (copper)
house supply ground wire & the green fixture ground wire. Note:
If house wiring does not include a ground wire, consult your local
electrical code for approved grounding methods.
For proper connection, place wire nut over wires
and twist clockwise until tight.
4. To Connect supply wires use wire nut (6) to connect the black
fixture wire to the black power supply wire and the white fixture
wire to the white (neutral) supply wire.
5. To Install fixture insert mounting screw (3) into center hole of
fixture housing. Align fixture over j-box and secure to cross bar by
tightening mounting screw. Note: make sure no wires are pinched
before tightening. Cover center hole in fixture housing with rubber
plug (7). See Fig A.

INSTALLATION INSTRUCTIONS

Quantity
1) LED Light Fixture
5) 3/4" Screws
Figure A
6. Aim lamp heads. Each lamphead can be positioned in multiple
directions via the adjustment knob (9) and the lock nut (8).
Note: Make sure to secure all lock nuts and adjustment knobs
tightly (do not overtighten) after final adjustments are made to
avoid water entry.
CAUTION - Risk of Shock: Aim lamp heads at least
20° down below horizontal in order to prevent water from
accumulating inside lens.
7. Turn on electricity at fuse or circuit breaker box and verify
success of installation.
Note: test fixture at night or block photocell. See Trouble shooing
guide for more info.
8. Apply silicone caulking (not included) around the
perimeter of the fixture back where it contacts the mounting
surface for moisture seal!
page 3
9) Adjustment Knob
8) Lock Nut
4) Cross Bar
6) Wire Nuts
7) Rubber Plug
3) Mounting Screw
2) Photocontrol