Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1. PREPARE FOR INSTALLATION
Remove fixture components and parts pack. Check to ensure
all parts are included. Note: Account for small parts and destroy
packing material, as these may be hazardous to children.
FIXTURE PACKING LIST
Part Description
A Light Fixture ......................................................................... 1
B Lamp Head .................................................................. 2 or 3
C Adjustable Daylight sensor (PE models only) ..................... 1
D Mounting bracket (pre-installed) ......................................... 1
E 1-1/4"(2H) & 2"(3H) Center Mounting Screw (pre-installed) 1
F 3/4" #8 & #6 & #10 Mounting Screws* ................................ 6
G Wire Nuts* ........................................................................... 3
H Rubber Plug*....................................................................... 1
*Contained in parts packs
Mounting Hardware Included
Silicone Sealant Required
REQUIRED TOOLS:
2. SELECT MOUNTING LOCATION
For installation to properly installed and grounded UL listed round
recessed or surface mounted weatherproof junction box.
Suitable for wall or eave mount. Not suitable for mounting within 4ft
(1.2m) from ground.
For models with Daylight Sensor (PE models)
Do NOT use with dimmers or timers or on multiple switch circuits.
Do NOT install on the same circuit with an electric motor (i.e.
appliances, HVAC equipment, washer/dryer, garage door
openers, etc.
Do NOT install Nearby large, light-colored objects reflecting
light may trigger the shut-off feature. Do not point other lights at
the daylight sensor.
3. INSTALLING MOUNTING BRACKET
Turn OFF Power at circuit breaker box
CAUTION: Do not rely on wall switch alone to turn off power.
Note: Center mounting screw and bracket are pre-installed on the
light fixture for shipping.
•
Loosen the center mounting screw (E) and remove the
mounting bracket.
•
Install the mounting bracket (D) to the junction box using two
3/4" #6 or #8 or #10 mounting screws (F).
Note: Choose one of the 3 screw sizes provided depending on
your junction box.
INSTALLATION INSTRUCTIONS
B
Quantity
4. CAUTION: WIRING
Make sure power is turned off.
•
Use wire nut to connect the bare copper or green house
supply ground wire to the green fixture ground wire. Note:
If house wiring does not include a ground wire, consult your
local electrical code for approved grounding methods.
For proper connection, place wire nut over wires
•
Use wire nut to connect the white fixture wire to the white
(neutral) house supply wire.
•
Use wire nut to connect the back fixture wire to the black
house supply wire.
5. MOISTURE SEAL
•
Apply silicone caulking (not included) around the perimeter
of the fixture back where it contacts the mounting surface for
moisture seal.
6. FIXTURE INSTALLATION
•
Align fixture over j-box and secure to mounting bracket by
tightening center mounting screw (E).
Note: Make sure no wires are pinched before tightening.
•
Insert rubber plug (H) into center hole to cover the center
mounting screw head for moisture seal.
Turn on electricity at fuse or circuit breaker box and verify success
of installation.
Note: If your model has an adjustable daylight sensor (PE
models) position cover as shown to block daylight from entering
sensor and allow lights to activate during daytime. See Trouble
shooing guide for more info.
page 3
D
A
C
E
H
and twist clockwise until tight.
SET DAYLIGHT SENSOR DIAL
Set dial in this position
to allow lights to
activate in daytime
F
G
Publicidad
Tabla de contenido
