Tabla de contenido
Publicidad
6.
Prepare the Wall Surrounds
(1) Mark the center of the
valves.
(1) Marquer le centre des
valves.
(1) Marque el centro de
las válvulas.
Prepare the Plumbing End Wall
NOTE: Holes for the mixing valve and shower must be cut into the plumbing end
wall.
Refer to the trim manufacturer's instructions for necessary hole sizes. Verify that
any escutcheon, flange, or cover plate is large enough to cover the hole for the
component.
Lay out and mark the centerline location for the mixing valve on the back side of
the end wall. (1)
Drill 1/4" (6 mm) pilot holes at the marked locations from the back side of the
end wall. (2)
CAUTION: Risk of product damage. Failure to follow directions regarding your
blade's cutting direction may damage the plumbing end wall finish. Cut the
holes from the front side of the wall for: hole saws, rotary tools, hand-held
jigsaws, or other saws with a blade that cuts on the push stroke. Cut the holes
from the back side of the wall for other reciprocating saws with a blade that
cuts on the pull stroke.
Carefully cut the fitting holes to the correct diameter. Refer to the trim
manufacturer's instructions for proper diameter. (3)
Carefully clean any debris from the receptor to reduce the risk of surface damage.
Optional Accessories
Sterling
(2) Drill the pilot holes on
the back of the wall.
(2) Percer les trous-pilotes
sur le mur arrière.
(2) Taladre los orificios guía
en la pared posterior.
21
(3) Cut the holes through
the front of the wall.
(3) Découper les orifices
dans le mur.
(3) Perfore los orificios a
través del frente de la
pared.
1092037-2-C
Publicidad
Tabla de contenido
