Tabla de contenido
Publicidad
Roughing-In
Series/Séries/Serie 7224, 7225, 7226
C
D
C
10" (25.4 cm)
8" (20.3 cm)
4" (10.2 cm)
4-1/2" (11.4 cm) D.
A
Ø 4-1/2" (11,4 cm)
4-1/2" (11,4 cm) D.
Roofing Nail Location (4 total)
Emplacement pour clou pour toiture (4 total)
Lugar para clavo de techar (4 en total)
Series/Séries/Serie 7227
D
C
C
A
NOTE: The diagram shown above is representative and for use with table below.
A
7224 series
36-1/8" (91.8
cm)
7225 series
42-1/8" (107
cm)
7226 series
48-1/8" (122.2
cm)
7227 series
60-1/8" (152.7
cm)
IMPORTANT! All dimensions are nominal. The stud opening tolerance is +1/8" (3
mm)/-0. Carefully measure your fixture before determining enclosure size. Some
shimming between the stud frame and the fixture may be required. If a firewall is
required, rough-in dimensions will have to increase according to the thickness of the
firewall material. Stud opening dimensions must be measured toward the exposed
side of the wall material. Dimensions given in the rough-in information are crucial for
proper installation. Construct the framing and plumbing accurately.
The stud locations must meet load bearing requirements, which are often specified by
local building codes. Studs must also allow for the installation of the plumbing fixtures
and shower doors.
Sterling
16-3/8"
(41.6 cm)
26" (66 cm)
3-1/4" (8.3 cm) D.
B
Ø 3-1/4" (8,3 cm)
3-1/4" (8,3 cm) D.
7-5/8"
(19.4 cm)
10" (25.4 cm)
26"
(66 cm)
8"
(20.3 cm)
Roofing Nail Location (5 total)
Emplacement pour clou pour
4" (10.2 cm)
toiture (5 total)
4-1/2" (11.4 cm) D.
Lugar para clavo de techar
Ø 4-1/2" (11,4 cm)
(5 en total)
4-1/2" (11,4 cm) D.
B
C
18" (45.7 cm)
10" (25.4 cm)
21" (53.3 cm)
13" (33 cm)
24" (61 cm)
16" (40.6 cm)
30" (76.2 cm)
16" (40.6 cm)
7
37-1/4"
(94.6 cm)
A
77"
(195.6 cm)
D
16" (40.6 cm)
16" (40.6 cm)
16" (40.6 cm)
14" (35.6 cm)
1092037-2-C
Publicidad
Tabla de contenido
