Hardware Characteristics - WEG EAN2 Guía De Instalación, Configuración Y Operación

4. Fasten the grounding screw of the accessory to the servo drive, as shown in
page 9.
5. Power up the control module and check on the corresponding slot parameter if the accessory
was correctly identified.

5 HARDWARE CHARACTERISTICS

The accessory EAN2 has the following hardware characteristics:
2 analog outputs with range of -10 V to +10 V and resolution of 12 bits.
„
Figure 5.1 on page 10
Figure 4.3: Fastening of the accessory grounding screw
Figure 4.4: Accessory connected
shows the accessory EAN2.
Analog Outputs Expansion Module - EAN2
Figure 4.3 on
SCA06 | 9