Atlas Copco LSF28 S250-2 Instrucciones Del Producto Original página 4

Safety and operating instructions
Installation, Operation and Maintenance:
precautions
T
WARNING Explosives and explosive gases,
explosion hazard
If the product comes into contact with explosives,
an explosion could occur. Explosions can lead to
serious injuries or death.
Sparks can fly when operating the product, these
can detonate highly flammable dusts and gases and
lead to fire or explosions.
Never operate the product near explosives
►
Never work in a highly flammable or explosive
►
environment
Make sure there are no hidden gas sources in your
►
working area
T
WARNING Electric shock
Should the product come in contact with electric
circuits or other electrical power sources, there is a
risk of serious injury or death.
Never work near electric circuits or other electrical
►
power sources
Make sure there are no hidden electric circuits in
►
your working area
T
WARNING Dust hazard
Some dust, fumes or other airborne material created
by power sanding, sawing, grinding, drilling and
other constructions activities contains chemicals
known to the State of California to cause cancer and
birth defects or other reproductive harm. Some ex-
amples of such chemicals are:
Crystalline silica and cement and other masonry
products.
Arsenic and chromium from chemically-treated
rubber.
Lead from lead based paints.
To reduce your exposure to these chemicals, work
►
in a well ventilated area, and work with approved
safety equipment, such as dust masks that are
specially designed to filter out microscopic
particles
Avoid inhaling dust or handling debris from the
►
work process which can be harmful to your health
Use dust extraction e.g. spot suction equipment
►
and wear respiratory protective equipment when
working with materials which produce airborne
particles
Potentially explosive atmospheres can be caused
►
by dust and fumes resulting from sanding or
grinding. Always use dust extraction or suppres-
sion systems which are suitable for the material
being processed
4
EN
© Atlas Copco Industrial Technique AB - 9836 2488 00
T
WARNING Projectiles
During power sanding, sawing, grinding, drilling
and other construction activities sparks, chips, wheel
fragments or other particles may turn into projectiles
and cause bodily injury by hitting the operator or
other persons.
Even small projectiles can injure your eyes and
cause blindness.
Always wear impact-resistant eye and face protec-
►
tion when engaging in or working near the opera-
tion, repair or maintenance of the tool or changing
accessories on the tool
Use barriers to protect others from wheel frag-
►
ments and grinding sparks
Check that all others in the area are wearing im-
►
pact-resistant eye and face protection
T
WARNING Noise hazard
High sound levels may cause permanent hearing loss.
Use hearing protection in accordance with occu-
►
pational health and safety regulations
T
WARNING Vibration hazard
Exposure to vibration can damage the nerves and
disable the blood supply of the hands and arms.
Repetitive work motions, awkward positions and
►
exposure to vibration can be harmful to hands and
arms. If numbness, tingling, pain or whitening of
the skin occurs, stop using the tool and consult a
physician
Insert tools with a bent shank should not be used
►
Use vibration dampened tools when available
►
Minimize time of exposure to vibration
►
T
WARNING Polymer hazard
The vanes in this product contain PTFE (a synthetic
fluoropolymer). Due to wear, PTFE particles might
be present inside the product. If heated PTFE can
produce fumes which may cause polymer fume fever
with flu-like symptoms, especially when smoking
contaminated tobacco.
Health and Safety recommendations for PTFE
must be followed when handling vanes and other
components:
Do not smoke when servicing this product
►
PTFE-particles must not come in contact with
►
open fire, glow or heat
Motor components must be washed with cleaning
►
fluid and not blown clear with an air line
Wash your hands before commencing any other
►
activity
LSF28 S250-2