Otto Bock 12K100-RENTAL DynamicArm Instrucciones De Alineamiento Y Montaje página 19

10 Assemble the Rental DynamicArm®
After adaptation of the 12K100=RENTAL Rental DynamicArm®, you can fit the prosthesis with the prosthetic
socket.
1. Dismantle the lamination ring of the 12K100=RENTAL as well as the prosthetic socket of the 12K100
DynamicArm® (see section 6, items 4 – 7).
2. Screw the socket onto the elbow joint. Or turn the friction screw until the socket can be screwed on the
elbow joint (see 647G152 Instructions for Use).
3. Remove the Allen head screw. Then replace the red assembly clamp with the band clamp and reinstall the
Allen head screws (see 647G152 Instructions for Use).
4. Turn the friction screw to set the friction of humeral rotation (see 647G152 Instructions for Use).
5. Adjust compensation to the patient by turning the finger wheel (see 647G152 Instructions for Use).
11 Technical Data
Power supply:
Maximum speed *):
Max. flexion angle:
*) Minimum lifting time is 0.5 sec, depending on the length of the forearm, on the terminal device used and the
optimal compensation with AFB.
12 Liability
Otto Bock Healthcare Products GmbH, hereinafter called manufacturer, assumes liability only if the user observes
the product's specified fabrication and use instructions, adheres to its care instructions, and follows its service
schedule. This product may only be used in combination with components that have been authorized by the manu-
facturer (please refer to the instructions for use and catalogs). The manufacturer does not assume liability for
damage caused by component combinations and applications that were not authorized by the manufacturer.
This product may only be opened and repaired by authorized Otto Bock staff.
13 CE conformity
This product meets the requirements of the 93/42/EWG guidelines for medical products. This product has been
classified as a class I product according to the classification criteria outlined in appendix IX of the guidelines.
The declaration of conformity was therefore created by Otto Bock with sole responsibility according to appendix
VII of the guidelines.
Li-Ion battery 1800 mAh
270° / sec
15° – 145°
19