Korg KAOSS PAD KP3+ Manual De Usuario página 14

Start Point setting
1. The SHIFT button will be lit, and the speci-
fied SAMPLE BANK button will change to
blinking.
The display will show the loop start point set-
ting.
2. Use the PROGRAM/BPM knob to adjust
the start point in steps of 1/32nd of a beat, over
a range of ± 1 beat.
TIP You can't select this setting for one-shot sam-
ples.
Slice setting
Loop samples can be sliced into equal parts.
You can select whether each sliced part will
play or not play. Sliced parts that do not play
are skipped, so the overall length of the loop
will be made shorter. This allows you to cre-
ate a variety of new rhythmic figures and loops
from the same original data. For example by
playing only the first two beats and last two
beats of a four-measure sample to create a
one-measure loop.
1. The SHIFT button will be lit, and the speci-
fied SAMPLE BANK button will change to
blinking.
2. All eight PROGRAM MEMORY buttons will
light up (by default).
By pressing the corresponding button you can
turn on or off each sample slice.
TIP You can't select this setting for one-shot sam-
ples.
Setting the Sample Playback Trigger
You can specify how a sample will be triggered
when the SAMPLE BANK button is pressed.
1. Enter the sample edit page.
If the display shows the start point setting,
press the PROGRAM/BPM knob to see the
trigger type specified for the selected sample.
2. Turn the PROGRAM/BPM knob to select
the trigger type.
When you press the SAMPLE BANK button,
the sample playback will start and you can
check the sample.
14
When you press another SAMPLE BANK but-
ton, the sample to be edited will be changed.
3. When you press the SHIFT button, the set-
ting will be entered and the KP3+ will return to
its normal state.
TIP: A one-shot sample cannot be set for TYPE 1
and 2.
TIP: The setting selected here is disabled when the
sample program (from the program SMP.1 to CRS.4)
mode is selected or when the trigger is set to turn on
or off by MIDI message.
TIP: The trigger can be set for each sample.
Trigger Type List
Type 1 "1.-.-": When the sample is not heard,
the loop continues playing and each time the
SAMPLE BANK button is pressed, the volume
control is turned on or off.
Type 2 "2.-.g": When the sample is not heard,
the loop continues playing. The sample vol-
ume is set to on (Gate) only when the SAMPLE
BANK button is held down.
Type3 "3.r.-": In this setting, the sample al-
ways starts from the beginning (resetting).
Each time the SAMPLE BANK button is
pressed, the volume control is turned on or off.
Type 4 "4.r.g": The sample always starts from
the beginning (resetting). The sample is set to
on (Gate) only when the SAMPLE BANK but-
ton is held down.
Hold