Orion HCCA Serie Manual Del Usuario página 17

NOTE: Make sure all the equipment in the system is turned off when
making or breaking connections to the input RCA's or speaker termi-
nals. Turn on the system and slowly turn up the volume control only
after double checking all wire connections.
Power for systems with a single amplifier can be supplied by most
automotive electrical systems. Systems with multiple amplifiers may
require a higher capacity battery, alternator or the use of a storage
capacitor. We strongly recommend the use of an Orion Wired power
capacitor with an extra battery in larger stereo systems.
Orion amplifiers generate a certain amount of heat as part of normal
operation. Be sure the area around the amplifier is unobstructed to
allow adequate air circulation. Remember, beach blankets, last week's
laundry, school books and homework papers located on top of the
amplifier do not improve air flow and may become damaged.
You must first remove the top cover (see Removing the Top Cover
section) then end caps to mount the amplifier (mounting holes are
within). (1) Remove the screws first, (2) lift the end cap straight up
to detach from unit and then (3) pull away from the amplifier. Once
mounted replace end caps by following this process in reverse.
Figure 21
Figura 21
Abbildung 21
© 2009 Directed Electronics. All rights reserved.
Listed below are the majority of the tools required to perform an
installation. Having the proper tools will make the installation that
much easier. Some of these tools are necessities; some will just make
the job easier.
Allen Wrenches (3mm and 4mm)
DMM or VOM
Electric drill with assorted drill bits
Grommets
Heat shrink tubing
Marking pen
Nylon tie straps
Phillips and flat blade screw drivers
Pliers (standard and needle nose)
Reference CD with 1 kHz Sine Wave at 0dB level (all bits high)
RTA (real time analyzer)
Soldering iron and solder
Utility knife
Wire brush or sandpaper for chassis grounding
Wire crimper
3
2
Wire cutters
1
Wire strippers
16