Orion HCCA Serie Manual Del Usuario página 9

Enclosure
Type
0dB +3dB
Infinite Tune above Fs High X-Max
Baffle of woofer Drivers - Tune
above Fs of
woofer
Sealed Tune above Fs Tune above Fs
of woofer of woofer
Vented Tune to port Tune to port
frequency frequency
Sealed Tune above Fs Tune above Fs
Band-pass of woofer of woofer
Vented Tune to port Tune to port
Band-pass frequency frequency
Aperiodic Set crossover to Set crossover to
Fs of woofer Fs of woofer
The line outputs on Orion amplifiers offer easy system expansion and
can be used to route signal from the RCA line outputs to the next
Orion amplifier's RCA line inputs in the signal chain.
The crossover section of the Orion HCCA10002 and HCCA10004 ampli-
fiers are continuously variable and extremely flexible. There are eight
different crossover configurations possible allowing high-pass, low-
© 2009 Directed Electronics. All rights reserved.
Boost Levels
+6dB +10dB
Not Not
Recommended Recommended
High X-Max Not
Drivers - Tune Recommended
above Fs of
woofer
Tune to port fre- High X-Max
quency Drivers -Tune to
port frequency
High X-Max Not
Drivers - Tune Recommended
above Fs of
woofer
Tune to port fre- High X-Max
quency Drivers -Tune to
port frequency
Set crossover to Not
Fs of woofer Recommended
pass, and band-pass operation. This circuit is designed to optimize the
performance of subwoofers in all types of enclosures.
When using Orion loudspeakers, minor deviations from the recom-
mended frequency ranges can provide superior results depending on
your speaker locations and your vehicle acoustics. Setting crossover
frequencies higher than recommended will not cause damage and
may provide superior sonic results depending on your system's perfor-
mance goals. Refer to your loudspeaker owner's manual for assistance
in choosing the proper crossover frequencies for your system.
WARNING! DO NOT set crossover frequencies lower than the speak-
ers recommended operating range. This can cause driver failure that
is not covered by the manufacturer's warranty.
Controls the type of filter for the onboard active crossover. The
HCCA10004 has two switches, the upper switch is for channels 1/2, the
lower switch is for channels 3/4.
All position does not attenuate any frequencies and is for full
range speaker systems.
High attenuates low frequencies and is used for mid-range speak-
ers and tweeters.
Low attenuates high frequencies and is used for subwoofer
speakers.
When the switch is in the middle (ALL position), the low-pass crossover
is bypassed. When the switch is to the left (LOW position), the low-
pass crossover is active. The low-pass crossover is continuously variable
from 50Hz to 2kHz.
8