END PANEL LAYOUTS
HCCA10002
1
2
ESP
INPUT
L CH
HCCA10004
1
7
8
GAIN
LF
RANGE
ESP
HIGH
LOW
RF
1.
ESP
- Allows connection of a Directed ESP controller, like the
Bitwriter.
© 2009 Directed Electronics. All rights reserved.
3
4
5
6
REMOTE
GAIN
L
R
L
R
INPUT
OUTPUT
OUTPUT
R CH
BRIDGE 4 OHM
9
4
10
11
12 13
LF
L
LR
CH
LINE
REMOTE
INPUT
OUTPUT
INPUT
LR
MODE
OUT
GAIN
2 CH
F/R SUM
4 CH
PASS
RF
R
RR
RR
2.
Speakers
(HCCA10002 only, refer to the Speaker Connections section of
this guide.)
Figure 1
3.
Input -
Figura 1
equalizer (HCCA10002 only).
Abbildung 1
4.
RCA Line Output -
fiers, the RCA inputs and RCA output are the same signal and are
not affected by any amplifier functions.
5.
Speakers
6.
Remote Gain Input -
to control the gain level from the driver's seat.
7.
GAIN RANGE -
(for high power head units) or Low (for line level head units).
8.
Speakers
6
ers to these terminals. (HCCA10004 only, refer to the Speaker
Connections section of this guide.)
9.
Input
(Left Front and Right Front below) - Accepts RCA input from
a head unit, preamplifier, or equalizer (HCCA10004 only).
10.
Input
(Left Rear and Right Rear below) - see item 9
11.
Speakers
Figure 2
12.
2/4 Channel Switch -
Figura 2
a signal only present on the front inputs. 4 ch will allow a 4 chan-
Abbildung 2
nel output when signal is present on the front and rear inputs.
13.
Front/Rear Sum Switch -
channels together before sending the signal out the RCA line out.
If the switch is not engaged, then only the front left and front
right signals are sent to the RCA line out.
(Left channel) Connect the speakers to these terminals.
Accepts RCA input from a head unit, preamplifier, or
Provides easy connection to additional ampli-
(right channel) - HCCA10002 only see item 2
Connects optional RGC2 remote gain control
Selects the input sensitivity range to either High
(Left Front and Right Front below) Connect the speak-
(Right Rear and Left Rear below) see item 8
2ch setting will allow 4 channel output with
Allows you to sum the front and rear
3