Insignia NS-R5100 Guía Del Usario página 16

Receptor digital de av para teatro en casa
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Adjusting each channel level with test tone
The volume level of each channel can be
adjusted easily with the test tone function.
Note
When the SPEAKER button is set to off, the test
tone function does not work.
To adjust each channel level:
1 Press the TEST button.
The test tone mode is displayed and is heard
from each channel's speaker for two seconds
as follows:
FL—Front Left
C—Center
FR—Front Right
SR—Surround Right
SL—Surround Left
SW—Subwoofer
Note
When the speaker setting is "N (None or No)", the
test tone of the corresponding channel is not
available.
2 At each channel, press the select
buttons to adjust the level as desired until the
sound level of each speaker sounds equally
loud.
3 Press TEST to cancel the test tone function.
Adjusting the current channel level
After adjusting each channel level with test tone,
adjust the channel levels either according to the
program sources or to suit your tastes.
You can adjust the current channel levels as
desired. These adjusted levels are memorized
into user's memory (CAL), not into preset
memory (REF 1 and REF 2).
To adjust the current channel level:
1 Press the CHANNEL LEVEL button.
OR
The memory mode (CAL) is displayed for
several seconds. Wen the memory mode or
channel level disappears, you can press this
button again.
14
Insignia NS-R5100 AV Digital Home Theater Receiver
2 Press the select
channel.
The corresponding channel is selected as
follows:
Note
3 Press the select
level of the channel.
The LFE level can be adjusted within the
range of -10~0 dB and other channel levels
within the range of -15 ~ +15 dB.
In general, we recommend the LFE level to
be adjusted to 0 dB.(However, the
recommended LFE level for some early DTS
software is -10 dB.) If the recommended
levels seem too high, lower the setting as
necessary.
or
4 Repeat this procedure to adjust each channel
level.
Memorizing the adjusted channel levels
You can memorize the adjusted channel levels
into preset memory (REF 1 or REF 2) and recall
the memorized levels whenever you want.
To memorize the adjusted channel levels:
1 After completing the steps under "Adjusting
the current channel level" on page 14, press
the MEMORY/ENTER button.
The 1 of the REF 1 indicator flickers for
several seconds.
2 Press the select
REF 1 or REF 2.
If the preset memory disappears, repeat
step 1 above.
3 Press the MEMORY/ENTER button to
confirm your selection. The adjusted channel
levels have now been memorized into the
selected memory.
www.insignia-products.com
or
buttons to select the
REF 1, 2 (or CAL)
FL
C
FR
SR
SL
SW
DTS or DD—Only when the digital signals
from Dolby Digital or DTS program
sources are input, these levels can be
displayed.
• Depending on the speaker settings ("N (None
or No)") and surround mode, some channels
cannot be selected.
• When the SPEAKER button is set to off, only
the Front Left and Front Right channels can be
selected.
• The LFE level (DD and DTS) is applied after
exiting the menu.
or
button to adjust the
OR
or
buttons to select

Publicidad

Tabla de contenido
loading

Tabla de contenido