Connecting Video Components - Insignia NS-R5100 Guía Del Usario

2 Connect the AM loop antenna to the receiver.
1
AM Loop Antenna
Note
Place the AM loop antenna as far as possible from
the receiver, television, speaker cords, and the AC
cord. Change the position of the antenna until you
get the best reception of your favorite AM stations.
Note
To improve reception, you may use an outdoor AM
antenna instead of a loop AM antenna.
Disconnect the indoor antenna before replacing it
with an outdoor antenna.

Connecting video components

About video connections
Connector type
Composite (RCA type plug)
S-Video
Component (Y, P /C
B
Connecting components
VIDEO 2
6
2
AM Outdoor Antenna
FM 75Ω
Ground
AM Loop
Quality
Good
Better
, P /C ) Best
B R R
VIDEO 1
Monitor
www.insignia-products.com
Insignia NS-R5100 AV Digital Home Theater Receiver
To connect your video components:
1 Connect your video cable to the receiver
based on the type of device you are
connecting.
Jack Device
VIDEO 1 VCR, DVD recorder or other digital
recorder.
VIDEO 2 Cable or satellite box, DVD player, or LD
player.
MONITOR Television, projector, or LCD monitor.
VIDEO 3 Camcorder or video game player. This jack
is located on the front of the receiver.
2 Connect the other end of the cable to the
device.
Note
If you are using the component video connections,
make sure that you are connecting Y to Y, P
to C , P , or B-Y and P
B B
Note
When recording video sources through the
VIDEO 1 OUT jacks or viewing video sources
through the MONITOR OUT jack, you must use
the same type of video jacks that you used to
connect to the video playback components.
/C
B B
/C to C , P , or R-Y.
R R R R