5. SERVICE
a.
Have your power tool serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
b.
Only use original parts for repair and maintenance. The use of incompatible accessories or spare parts
can result in electric shocks or other injuries.
Symbols used in this manual
V.............volts
A.............amperes
Hz............hertz
W............watt
~.............alternating current
n
...........no load speed
0
min
.........revolutions or reciprocation
-1
per minute
......warning of general danger
....with electrical earth
DRILL SAFETY WARNINGS
•
Use auxiliary handle(s). Loss of control can cause personal injury.
•
Hold power tool by insulated gripping surfaces, when performing an operation where the cutting
accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and could give the operator an electric shock.
•
Never use the machine without the PRCD fault-current safety switch supplied.
•
Always check the PRCD fault-current safety switch for correct functioning before starting a drilling
operation.
•
Ensure that no water is allowed to get into the motor unit during operation.
•
If you detect a leak in any part of the water supply system, shut the machine down immediately
and repair the fault. Water pressure should not exceed 70 psi (4 bar).
•
Block off the working area and place warning signs on both sides of the wall when drilling through
from one side to the other.
•
Take appropriate precautions to ensure that, in the event of a drilling core dropping out, no
personal injury or material damage will result.
•
When drilling hollow components, check the flow route of the cooling water in order to prevent
damage.
GB
.......read these instructions
......always wear eye protection
......always wear a dust mask.
.....always wear hearing protection
.....wear safety-approved hard hat
do not dispose of electric tools,
accessories and packaging together
with household waste material
5