Craftsman 580.768330 Manual De Instrucciones página 11

• Whenthewatersupply is steady andconstant,
engage thesafetylatchandrefasten thenozzle
extension.
Nozzle Maintenance
If a nozzle becomes restricted or clogged with dirt or
foreign materials, a pulsing sensation during use may
occur. This is caused by excessive pump pressure.
Immediately clean a clogged or partially restricted
nozzle with the kit included with your pressure washer
by following these instructions:
• Shut off the engine and turn off the water supply.
• Disengage the safety latch and pull the trigger on
the spray gun and hold until all water is purged
from the unit. Engage the safety latch on the spray
gun.
• Remove the nozzle from the end of the nozzle
extension.
• Use the wire included in the kit or a small paper
clip to free the foreign materials clogging or
restricting the nozzle.
O
1 o-ring, yellow, (p/n B2264) for the end of the
high pressure hose.
Use wire here to ,.JL__
remove debris. _ NOTE: The previous two o-rings are close in size.
__ Please match carefully to assure proper o-ring usage.
• Remove additional debris by rinsing out the nozzle.
Rinse between 30 to 60 seconds.
• Reinstall the nozzle into the nozzle extension.
• Reconnect the water supply, turn on the water, and
start the engine.
• Disengage safety latch on the spray gun.
• Test the pressure washer.
O-Ring Maintenance
Through the normal operation of your pressure
washer, o-rings keep the connections of the hoses
and spray gun tight and leak-free. They may become
worn or damaged with use.
Provided with your pressure washer is an O-Ring
Maintenance Kit which includes replacement o-rings,
rubber washer and water inlet filter. Refer to the
instruction sheet provided in the kit to service your
unit's o-rings. Note that not all of the parts in the kit
will be used on your unit.
1 o-ring, blue, (p/n B3065) for the inside of the
nozzle extension quick connect.
1 rubber washer, (p/n B2385) for the inside of the
garden hose connector.
Parts in the O-Ring Kit Include:
• 1 o-ring, red, (p/n B2726) for the end of the spray
gun connection between spray gun and nozzle
extension.
• 1 water inlet screen (p/n B2384) for the garden
hose connector.
To remove a worn or damaged O-Ring:
• Use a small flathead screwdriver to get underneath
the o-ring to gently pry it off.
11