LUCCI Air AIRFUSION A Manual De Operación, Instalación Y Mantenimiento página 8

Airfusion Type A Installation Instructions

Turn on the power to receiver 1. Keep the power OFF to receiver 2. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).

Press and hold the "
the receiver of ceiling fan 1.

Turn ON and change the speed of the ceiling fan 1 by the transmitter to check the operation and successful
paring.
Setting DC Ceiling fan 2:

Turn off both ceiling fans 1 and 2 via the mains supply to the receiver.

Install the 2x1.5VDC batteries in the compartment. Please make sure the polarity of the battery is correct.

Turn on the power to receiver 2. Keep the power OFF to receiver 1. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).

Press and hold the "
the receiver of ceiling fan 2.

Turn ON and change the speed of ceiling fan 2 by the transmitter to check the operation and successful pairing.
Note: The pairing of transmitter and receiver is required if only one ceiling fan is installed. When more than
two ceiling fans are installed near each other, please refer to the instruction above.
Remote Control Buttons
: FAN ON/OFF BUTTON (A):

Press the button to turn the fan on/off.

Press and hold the button for 3 seconds within 60 seconds of switching the power to the receiver for pairing the
transmitter and receiver.
+
: SPEED INCREASE BUTTON (B): Press the button to increase the fan speed. The LED indicator (D) will indicate
the fan speed (1-12 speed) accordingly.
7 | P a g e
" button on transmitter 1 for 3 seconds within 60 seconds of switching the power to
" button on transmitter 2 for 3 seconds within 60 seconds of switching the power to
Fig. 10