Using Your Ceiling Fan - LUCCI Air AIRFUSION A Manual De Operación, Instalación Y Mantenimiento

Airfusion Type A Installation Instructions
INSTALL CANOPY

Loosen the 2 screws from the bottom of the mounting bracket. Fig. 7

Slide the canopy up to the mounting bracket and place the key hole on the canopy over the screw on the
mounting bracket, turn the canopy until it locks in place at the narrow section of the key holes and secure it
by tightening the two set screws. Avoid damaging the electrical wiring prepared previously.
BLADE INSTALLATION

Insert the blade screws through the blade then secure the blade to the motor by tightening the 3 screws.
Fig.8

Repeat this process to install the other blades to the motor.

Finally install the bottom cover to the shaft by rotating it clockwise. Fig. 9
Pairing Transmitter and Receiver – when 2 or more DC ceiling fans are installed in one location
When two or more fans are located near each other, you may want to have the receiver/transmitter for each fan set to
a different code, so that the operation of one fan does not affect the operation of the other fan/s.
NOTE: Ensure power to the receiver is ON prior to pairing the transmitter with the receiver.
Transmitter/Receiver pairing for ceiling fan 1:

Turn off both ceiling fans 1 and 2 via the mains supply to the receiver.

Install the 2 x 1.5VDC batteries in the compartment. Please make sure the polarity of the battery is correct.
6 | P a g e
Fig. 8 Fig. 9

USING YOUR CEILING FAN

Fig. 7