User Interface - NOCO Genius G7200 Manual Del Usuario

16 USING THE G7200

USER INTERFACE

12V NORM LED
Charge mode for
12V Wet, Gel and MF
batteries.
(14-230Ah)
WICKED SMART FEATURE
ERROR CONDITION. An ERROR condition could happen for multiple
reasons. If an ERROR condition occurs, the ERROR LED and CHARGE
LEDs (25%, 50%, 75%, 100%) will blink "on" and "off" at 5Hz. For
assistance in resolving ERRORs, see the section entitled,
"TROUBLESHOOTING."
Now That's Smart, Wicked Smart.™
MODE BUTTON
The MODE button
is used to select
the charging modes
manually.
12V COLD/AGM
LED
Charge mode for
12V batteries below
32°F (0°C) and AGM
batteries.
(14-230Ah)
ERROR LED
CHARGE LEVEL
The ERROR LED (Orange)
Indicates the current
will illuminate when an error
charge level of the
condition or reverse polarity
battery.
is present.
24V NORM LED 24V COLD/AGM
Charge mode for
LED
24V Wet, Gel and
Charge mode for
MF batteries.
24V batteries below
(14-120Ah)
32°F (0°C) and AGM
batteries.
(14-120Ah)
WICKED SMART FEATURE
EXTENSION CABLE ACCESSORY. If you have a preferred location,
but the length of the battery connectors is too short, you can use
an Extension Cable to increase the length. A 10' Extension Cable is
available from NOCO Genius, Model Number GC004. Using an Extension
Cable may increase the battery charge times.
Now That's Smart, Wicked Smart.™
USING THE G7200
STANDBY LED
The STANDBY LED
(Green) illuminates
when a charging
mode has not been
selected.
13.6V SUPPLY 16V BOOST LED
A 12V charge mode
LED
for recovering battery
A 12V charge mode
capacity from sulfated
for maintenance
batteries.
charging or low
(14-230Ah)
voltage batteries.
(14-230Ah)
G7200
geniuschargers.com
17