Publicidad
Idiomas disponibles
Idiomas disponibles
therefore avoid touching the red-hot surfaces with bare skin. Turn the
product off and wait at least 5 minutes before carrying out any repairs.
14.Do not modify the appliance in any way.
15.Pay particular attention when used in unmanned environments.
16. Periodically inspect the completeness of the appliance by eye. In the event
of any imperfection do not use it and immediately contact the manufacturer
or an authorized Technical Assistance Centre.
17. Before cleaning or doing any maintenance turn the product off and
disconnect it from the electricity network by switching the plant off.
18. If the product falls or receives a hard knock get it checked by the
manufacturer or an authorized Technical Assistance Centre.
19. During maintenance do not touch the bulbs directly but handle only by
the end caps. The bulb can be damaged by contact with bare hands; in this
case the covering warranty is no longer valid.
20. Should you accidently touch the surface of the bulb, clean it immediately
with a soft cloth moistened with alcohol.
21. In the event of malfunction and/or breakdown turn the appliance off
and immediately contact the manufacturer or an Authorized Technical
Assistance Centre.
22. Original spare parts must be used in any repairs. In the event of
damage to the lead or its plug immediately replace it, this should be
carried out at the premises of the manufacturer or an authorized
Technical Assistance Centre.Use a lead with similar characteristics.
23.Switch the main plant supply off when:
there is a malfunction;
a)
you decide to clean the outside;
b)
you decide not to use the appliance for a long period of time.
c)
24.Do not cover or obstruct the front grille when in use.
25.Do not cover or obstruct the appliance whilst it is on.
26.Keep the front grille clean.
27. If you decide to permanently remove the appliance, switch it off and
disconnect it from the mains, and then keep it well out of the reach of
children and the handicapped. It is also recommended to make it
unusable by cutting its supply cable off.
28. Do not use the appliance in conjunction with programmers, timers or
other tools capable of turning it on automatically without the presence of
an operator.
29. Heaters must be switched on and switched off one by one. Do not use the
main switchboard for switching on or switching off the units, to avoid
voltage surges which could burn out the bulb.
10
Publicidad
