Fulgor Milano FCH 905 ID TS G DWK Instrucciones Para La Instalación Y Uso página 60

Error code
C
C/-
GB
E/7
E/8
E/9
E/A
E/C
E/H
No functionality
and no displaying
E
E/2
(Error code
different for some
UI)
description
The cooking zone can
be configured if a static
"C" is shown.
The cooking zone will be
configured if a blinking
"C" is shown. After a
successful configuration
the relevant display
shows "-".
When the "-" is not
displayed please check
the possible causes of
the E/5.
Non assignable faillure.
Fan faillure.
Defect T sensor on
inductor.
Hardware defect of
induction modul.
Configuration failure.
Fixed sensor value (test
function for T sensor on
inductor).
Overvoltage on the
switch mode power
supply (jno fuctionality).
A blinking "E" on each
cooking zone indicates,
that all configs will be.
Temperature limits are
excessed.
Possible causes
It's not an error, the user
is in the serivice menu.
The user is in the
service menue, it's not
an error.
2. over voltage.
Fan or control electronic
is defect.
Sensor signal out of
valid range; sensor or
electronic is defect.
Defect hardware device
detected by the self
check of the modul.
2 cooking zone are
dedicated to the same
element of the UI.
Not enough temperature
change (10K) within 5
min after switch on the
hob.
400V connection.
The user is in the
service menù, it's not an
error.
1. Pot or glas
temperature is to
2. NTC - electronik
temperature to high.
60
Error recovery
A suitably pan must be
placed on the relevant
cooking zone.
Wait for the sysmbol
"-" or abort the
configuratuib activities
by pressing the
selectkey and the "C"
does not blink anymore.
Exchange the module.
Exchange modul or User
Interface.
Exchange the modul.
Exchange the modul.
Exchange the modul.
1. Erase the actual
configuration manual
with service menù.
Systerm must cool
down.
Disconnet and
correct the power line
connection.
Manual configuration.
System must cool down.