Adjusting the Volume
To increase or decrease the sound level, press:
The remote control Volume buttons.
■
Or
The TV Volume buttons.
The indicator bar on the TV shows the increase or
decrease.
Muting the sound
1
Press the Mute button on the remote control to
temporarily turn off the sound.
2
Press the Mute button again to restore the sound
back to the previous level.
Changing the Picture
Mode
Press the Picture button on the remote control to display
the currently selected video mode. Keep pressing the
Picture button until you reach the desired picture. The
Picture modes are:
Standard: Good for normal viewing conditions
■
with low room lighting.
Movie: Good for watching movies in a darkened
■
room. Provides a soft, film-like picture.
Vivid: Good for viewing in a well-lit room,
■
enhances the contrast and sharpness.
User: Displays the custom settings that you
■
configured in the OSD. For more information
about defining the picture settings, see "Using the
Picture Menu" on page 30.
24
HP HDTV User's Guide
Changing Channels
To change to the next higher or lower channel, press:
The remote control Ch+ or Ch– buttons.
■
Or
The TV Channel buttons.
To change to another channel, enter a one-digit, two-
digit, or three-digit number, or press the channel up or
down buttons.
To select a specific channel number (for example,
channel 25), complete the following procedure within
four seconds:
1
Press the 2 button on the remote control.
2
Press the 5 button.
3
Press Enter.
To select a specific digital channel number (for
example, 14-2) complete the following procedure
within four seconds:
1
Press the 1 button on the remote control.
2
Press the 4 button.
3
Press the – (dash) button.
4
Press the 2 button.
5
Press Enter.
Selecting the last channel
Press the Last button on the remote control to view the
previous channel that you viewed.
Selecting a favorite channel
You can quickly select a favorite channel by using the
Fav button on the remote control.
Press the Fav button on the remote control to view a list
of your favorite channels. Press an arrow button to
select a channel from the list, and then press OK.
Ch+
Ch-