Cisco LINKSYS Wireless-N WRT120N Manual Del Usuario página 15

Chapter 3
Wireless-N channel. Select any channel from the drop-
down menu. If you are not sure which channel to select,
keep the default, Auto.
Standard Channel If 20MHz only is the Channel Width
setting, then select the appropriate channel for your
wireless network. If you are not sure which channel to
select, then keep the default, Auto.
If 40MHz only is the Channel Width setting, then the
Standard Channel will be a secondary channel for
Wireless-N (2.4 GHz). If you selected a specific channel
for the Wide Channel setting, then the Standard Channel
options will be available. Select the appropriate channel
for your wireless network.
SSID Broadcast When wireless clients survey the local
area for wireless networks to associate with, they will
detect the SSID broadcast by the Router. To broadcast the
Router's SSID, keep the default, Enabled. If you do not want
to broadcast the Router's SSID, then select Disabled.
Click Save Settings to apply your changes, or click Cancel
Changes to clear your changes.
Wi-Fi Protected Setup
There are three methods available. Use the method that
applies to the client device you are configuring.
Wireless > Basic Wireless Settings (Wi-Fi Protected Setup)
Wireless-N Home Router
Advanced Configuration
Wi-Fi Protected Setup Configured
NOTE: Wi-Fi Protected Setup configures one
client device at a time. Repeat the instructions
for each client device that supports Wi-Fi
Protected Setup.
Method #1
Use this method if your client device has a Wi-Fi Protected
Setup button.
1. Click or press the Wi-Fi Protected Setup button on
the client device.
2. Click the Wi-Fi Protected Setup button on this
screen.
3. After the client device has been configured, click
OK. Then refer back to your client device or its
documentation for further instructions.
Wi-Fi Protected Setup > Congratulations
Method #2
Use this method if your client device has a Wi-Fi Protected
Setup PIN number.
1. Enter the PIN number in the field on this screen.
2. Click Register.
3. After the client device has been configured, click
OK. Then refer back to your client device or its
documentation for further instructions.
11