Kenmore 721.26082 Manual De Uso Y Cuidado página 10

Y.I I WARNING
Electrical Shock Hazard
Do not operate the cleaner without the
motor safety filter. Be sure the filter is dry
and properly installed to prevent motor
failure and/or electrical shock.
Check motor safety filter occasionally
and clean when dirty.
1. Unplug cord from wall outlet and lift
canister hood.
1. Unplug cord from wall outlet. DO NOT drip
water on cleaner.
2. Pull out the dust bin and motor safety
filter as shown.
3. Wash filter in warm soapy water, rinse,
then dry. Do not clean in dishwasher or
install while damp,
4. Insert motor safety filter back into canister.
5. Place the dust bin and close the hood.
2. Clean vacuum exterior using a clean, soft
cloth that has been dipped in clean water,
then wrung out. Wipe dry after cleaning.
NOTE: Regular cleaning helps to reduce static
electricity and dust buildup on outer surfaces of
cleaner and attachments.
CAUTION
DO NOT use attachments if they are wet.
Damage to motor may occur.
Attachments used in dirty areas, such as
under a refrigerator, should not be used
on other surfaces until they are washed
since they could leave marks.
When not in use, store the cleaner in upright
position by inserting nozzle clip into storage clip
in canister body as shown.
Nozzle Clip
/
-10-