Federal Signal Commander 371DST Instrucciones De Instalación Y Servicio página 6

2. Remove the two #8 screws retaining the fresnel lens to it's mounting base and lift the lens off the metal
spinning.
3. Carefullyremovetheflashtubefromitssocketbygraspingtheconnectorandlifting
upwards using a slight rocking motion.
4. See replacement parts table (Section IIB) for a complete list of Federal Signal lamps that
areavailable.Installanewflashtubebyfullyseatingitintothesocket.
5. Reassemble the unit.
6. Test light for proper operation.
B. Replacement Parts.
Description
Dome Assembly, Polycarbonate, Amber
Dome Assembly, Polycarbonate, Blue
Dome Assembly, Polycarbonate, Clear
Dome Assembly, Polycarbonate, Green
Dome Assembly, Polycarbonate, Red
Inner Lens, Polycarbonate Clear
Dome Ring Gasket
Surface-Mount Gasket
Strobe Tube
Printed Circuit Board Assy., 12-24VDC
Printed Circuit Board Assy., 120VAC
C. Optional Accessories.
Description
Mounting Bracket, Surface
Conduit hub kit, 3/4" N.P.T.
Close-up plug, 1" N.P.T.
III. SERVICE
The Federal Signal factory will service your equipment or provide technical assistance with any
problems that cannot be handled locally.
Any units returned to Federal Signal for service, inspection, or repair must be accompanied by a
Return Material Authorization. This R.M.A. can be obtained from a local Distributor or
Manufacturer's Representative.
At this time a brief explanation of the service requested, or the nature of the malfunction, should
be provided.
Address all communications and shipments to:
Industrial Systems
2645 Federal Signal Drive • University Park, IL 60484-3167
Tel.: 1-708-534-4756 • 1-877-289-3246 • Fax: 1-708-534-4852
www.federalsignal-indust.com • www.fs-isys.com
Part No.
K8459125
K8459125-01
K8459125-02
K8459125-03
K8459125-04
K8422B428
K8459123
K8459127
K8107178
K2001265-01
K200865-02
Part No.
371BRCKT
K8459138
K8459130
4