Packing List - Ferroli HRT-176RS Manual De Instalacion Y Uso

quest) to the OFF or ON position permanently by pressing
the receiver transparent button. The selected position is
indicated by the red or green light irregularly blinking. Once
the radio communication has been reactivated the receiver
will revert to work according the transmitter requests.

PACKING LIST

RF receiver with 4 wire cable fitted
RF transmitter
Screws and wall plugs (drill 5 mm)
Adhesive magnetic
Double side adhesive
Instructions
Batteries 1,5 AAA
BOILER PREPARATION
Isolate the appliance from the electrical supply and remove
the appliance casing and PCB cover (refer to boiler instal-
lation instructions for specific details).
Connect the spade terminals from the receiver to the PCB
terminals (room thermostat terminal black & black, main
supply terminals blue and brown on the main boiler supply
socket) - figure below for a sample boiler connections.
Blue = main supply 230 Vac = neutral N
Brown = main supply 230 Vac = line L
Black & Black = room thermostat = I-O
See above picture for the receiver internal
connections.
Remove the bridge
Black RF wires connections
CN6
CN5
QTY
1
CN13
1
P1
4
3
IMPORTANT: the link-wire (if fitted) must be removed from
2
room thermostat terminals
1
IMPORTANT: Secure the receiver wiring harness to the in-
2
ternal boiler cable anchors.
INSTALLATION OF RECEIVER
Secure the receiver in the proximity of the boiler using
the screws and wall plugs or using the adhesive magnet-
ic strips on the external boiler casing including to fix (both
fixing tools are provided).
The location should be chosen in order to see the receiv-
er light/button. For no reason should the receiver box be
opened. The appliance can only be mounted indoors and in
areas free from any water or moisture. Wiring must conform
to IEE regulations.
NOTA: do not fix the receiver in a permanent way to the
boiler casing.
INSTALLATION OF TRANSMITTER
The receiver and the transmitter are delivered already cou-
pled therefore the encoding procedure is not necessary at
the installation. In case it is required to encode the trans-
11
230 V
M3
CN12
1
JP5 JP4 JP3 JP2 JP1
JP6
P2
P3
N L
EN
F
brown RF
blue RF