Charging The Internal Battery - Snooper TRUCKMATE S7000 Guia De Inicio Rapido

2. Charging the internal battery

Although Truckmate can be charged using
the cigarette lighter in your vehicle, a
complete charge is more easily achieved by
using the 240V AC mains charger included.
When new, the battery in Truckmate is
approximately 20% charged.
To charge the unit fully, move the 'Batt. ON/
OFF' switch to the 'ON' position and connect
the 240V AC mains charger as indicated in
the picture on the right. The battery light
on Truckmate will illuminate and will take
approximately 3 hours to charge. When the
internal battery is fully charged, the red LED
will switch off. Once fully charged the battery
will last approximately 3 hrs during normal
use.
Note: The new battery's full performance is
only achieved after two or three complete
charges and discharges.
THERE IS A RISK OF EXPLOSION IF THE BATTERY IS REPLACED WITH AN
UNAPPROVED TYPE. USING THE WRONG TYPE OF BATTERY MAY DAMAGE
YOUR UNIT AND INVALIDATE YOUR WARRANTY. ONLY SNOOPER AUTHORISED
PERSONNEL SHOULD REPLACE THE BATTERY. PLEASE DISPOSE OF USED BATTERIES
ACCORDING TO LOCAL WASTE MANAGEMENT RULES AND REGULATIONS.
FURTHER INFORMATION CAN BE FOUND IN THE USER MANUAL ON THE
Plug the
charger cable into
the socket on the
back of the Truckmate
CAUTION
SOFTWARE CD.
5 • UK
Plug the charger into a
240V AC mains socket