(3.2) Charging The Battery; (3.4) Installing The Sim Card - Snooper SPT200 Guía De Usuario

(3.2) Charging the Battery

The SPT 200 Snooper Tracker incorporates a built-in rechargeable lithium polymer
battery.
The FULLY charged battery can supply power for the tracker for about 72 hours (In
stand by mode)
• Do not remove, puncture or damage the battery or throw the battery into fire or
water. Before you can use the SPT200 Snooper Tracker you must FULLY charge
the battery using the home or cigarette car charger for at least 3 hours. The unit
should be powered off to ensure that the battery is fully charged.
• Battery Charge status indicator:
Red light on – battery charging
Red light off – battery charging is complete
(3.3) Installing SIM card
Insert a valid GSM SIM card into the "SIM Card" slot on the right of your Snooper
Tracker
• (Note: Use the tool supllied to push the SIM card into the slot and the SIM card
will be locked in automatically.)
Please note you will need to ensure that the following SIM card settings are
correct before use. You may need to insert the sim card in to a mobile phone to
apply these settings.
1. Ensure that the Sim card is activated on the relevant network.
2. Switch off voice mail (you may need to contact the network provider to disable
this feature)
3. Check that the user ID of the mobile phone being used by an authorised user
has not been hidden.
Snooper Tracker User Guide (9 lang).indd 5
5
12/11/08 17:44:11