Installing Truckmate Using The Windscreen - Snooper TRUCKMATE S7000 Guia De Inicio Rapido

4. Installing Truckmate using the Windscreen Suction Cup bracket
You can mount Truckmate to the inside of your vehicles windscreen using the windscreen
bracket provided.
Clean the area where you wish to position
●
the bracket thoroughly with a good quality
glass cleaner. This allows a more secure seal
on the windscreen.
Place the suction cup and bracket on
●
the windscreen and push the locking
lever towards the windscreen to secure
the bracket.
Adjust the angle of the bracket so that
●
when the unit is attached to it you can
view the display and operate the controls
safely.
Position Truckmate onto the bracket, by
●
inserting the bottom of the S7000 first
and finally clipping the top of the bracket
into the slot on the back of the unit.
To remove Truckmate simply unclip the unit,
by pushing the top of the bracket and taking
the unit from the holder.
Truckmate can be powered directly either
●
from the internal battery if it is fully
charged or powered from the cigarette
lighter socket. To use the cigarette lighter
socket, plug the smaller plug on one
end of the power cable into the power
socket on the side of Truckmate and plug
the larger plug into the cigarette
lighter socket of your vehicle.
Please Note: Only use the cigarette lighter power cable provided with Truckmate.
Truckmate operates on 9V and using any other cigarette lighter power cable will
damage your device and void the warranty.
Locking
lever
7 • UK