Site Selection And Preparation - RealFlame 1330 Manual Del Usuario

SITE SELECTION AND PREPARATION

To reduce the risk of fire or electric shock when installing:
• Make sure the power cord is not pinched or against a sharp edge when installed.
• Ensure that the power cord is stored or secured to avoid tripping or snagging.
• Construction and electrical outlet wiring must comply with local building codes
and other applicable regulations.
• Do not attempt to wire your own new outlets or circuits. Always call a licensed
electrician.
See figure 1 for grounding instruction.
This heater is for use on 120 volts.
The cord has a plug as shown at A in
Figure 1. An adapter as shown at C is
available for connecting three-blade
grounding-type plugs to two-slot
receptacles. The green grounding lug
extending from the adapter must be
connected to a permanent ground
such as a properly grounded outlet
box. The adapter should not be used
if a three-slot grounded receptacle is
available.
WARNING
GROUNDING PIN
GROUNDING
MEANS
NOTE: This adapter is
prohibited in Canada.
5
COVER OF GROUNDED
OUTLET BOX
METAL SCREW
NOTE: This adapter is
prohibited in Canada.
*ADAPTER
GROUNDING PIN
Fig. 1