Petsafe SmartDoor Guia Del Usuario página 6

Step 5: Programming your Electronic SmartDoor
Important: It is advised that you program and test your Electronic SmartDoor prior to
installation. It must be in the vertical position for the fl ap to center and operate properly.
1. Programming your Electronic SmartDoor to learn the SmartKey:
Press and hold the LEARN button until the green LED begins to fl ash. Release the button. Bring
the SmartKey into range of the Electronic SmartDoor; the green LED will stop blinking and will
illuminate for 2 seconds. The code has been successfully added to memory. Up to fi ve different
SmartKey codes can be added to memory. Only one SmartKey can be programmed into the
SmartDoor at a time. Only the SmartKey being programmed should have a battery in it. When all
SmartKeys have been programmed you may put in the batteries in all the SmartKeys. Learn Mode
may be accessed when the Electronic SmartDoor is in any operating mode. When the Learn mode is
activated, if no SmartKey transmitter signal is detected, the green LED will blink for 60 seconds and
extinguish; the Electronic SmartDoor will return to its previous mode.
2. Choosing Automatic, Unlocked, or Locked Mode
Automatic Mode – The SmartDoor will only open for the SmartKey.
To enter Automatic mode, press and hold the Mode/Reset button: the green LED will illuminate
indicating Unlocked mode, then the yellow LED will illuminate. While the yellow LED is
illuminated, release the Mode/Reset button. The fl ap will enter Automatic mode. The fl ap will move
down (locking). When the unit senses the SmartKey, the fl ap will unlock. When the SmartKey signal
is no longer detected, the fl ap will relock. The SmartKey must be out of the range of the Electronic
SmartDoor for 10 seconds before the door will respond to the SmartKey signal again. If your pet
stays in the range of the door, it will stay unlocked.
Unlocked Mode – The SmartDoor is always unlocked.
To enter the Unlocked mode, press and hold the Mode/Reset button; the red LED will illuminate
indicating Locked mode, then the green LED will illuminate. While the green LED is illuminated,
release the Mode/Reset button. The fl ap will unlock.
Locked Mode – The SmartDoor is always locked.
The Electronic SmartDoor ships from the factory in the Locked mode. The Electronic SmartDoor
will enter Locked mode when the 4 D-cell batteries are placed in the Battery Box. To enter Locked
mode when the Electronic SmartDoor is in either the Unlocked or Automatic mode, press and hold
the Mode/Reset button until the red LED is illuminated. While the red LED is illuminated, release
the Mode/Reset button. The fl ap is locked.
Error Mode – When the LED is fl ashing, the Electronic SmartDoor is in Error mode, indicating
an error has occurred. If the fl ap is off-of-center, either to the inside or outside, while the fl ap is
lowering, the Electronic SmartDoor will stop moving the fl ap down and the yellow LED will begin
fl ashing. The Electronic SmartDoor will remain in Error mode until the error has cleared. See
"Troubleshooting" on page 7.
Step 6: Attach the SmartKey
Thread your pet's collar through the SmartKey's attachment
loop. Your pet's collar must be ¾" wide or less. The SmartKey
should hang under the pet's neck.
If your pet's collar is too large to thread through the key, a key
ring has been provided. Use for attachment to your pet's collar
ring.
Step 7: Installing your Electronic SmartDoor
See accompanying installation template for installation instructions.
6 1-800-732-2677 (US), 1-800-457-3911 (Canada)
to the Pet's Collar
™
™ for Use