Fireplace Installation; Mantel Installation - Dimplex DF2000L Manual Del Propietário

Fireplace Installation

Fireplace Installation
!
NOTE: A 15 Amp, 120 Volt
alternating current (VAC) circuit
is required. A dedicated circuit
is preferred but not essential in
all cases. A dedicated circuit will
be required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when the
heater is operating. Additional
appliances on the same circuit
may exceed the current rating of
the circuit breaker.
WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of fire, electric shock or injury to
persons.
Construction and electrical outlet
wiring must comply with local
building codes and other applica-
ble regulations to reduce the risk
of fire, electric shock and injury to
persons. Do not attempt to wire
your own new outlets or circuits.
To reduce the risk of fire, electric
shock or injury to persons, always
use a licensed electrician.
1. Make sure the units 3-Posi-
tion switch is switched OFF
(refer to operating instruction
section).
2. Plug the unit directly into a 15
Amp/120 VAC outlet.

Mantel Installation

For use with a new or existing
mantel. Depending on the avail-
able space within the mantel cav-
ity, the unit can be secured to the
mantel at the bottom side or back.
Remove the screw on the bottom
flange in the most appropriate
place for securing and using the
provided L-bracket and the screw
that was removed attach the fire-
box to the mantel. (Figure 1)
!
NOTE: There are no guide
holes provided for the L-Brackets
in the mantel.
Figure 1
7