Cleaning/Replacing The Impeller Unit - Oase AquaMax Eco Titanium 31000 Instrucciones De Uso

Cleaning/replacing the impeller unit

WARNING
The impeller unit rotates very fast. Do not reach into the openings of the suction
socket or pressure socket as there is a risk of severe injury such as loss of limb.
Disconnect the power plug before carrying out any work on the unit.

NOTE
The impeller unit contains strong magnets that attract magnetic particles (e.g. iron
filings). Any remaining particles can cause irreparable damage to the impeller unit
and motor block.
Carefully remove any adhering particles from the impeller unit prior to installation.

NOTE
The impeller unit is guided in the motor block by a bearing. This bearing is a wear
part and should be changed at the same time as the impeller unit.
Changing the bearing requires specialist knowledge and tools. Have the bearing

changed by the OASE specialist dealer or send the pump to OASE.
• Remove the pipes on the suction side and on the pressure side.
• Use a wide-blade screwdriver to carefully lever out the impeller unit if necessary.
• After removing the impeller unit, clean all parts under running tap water.
– Replace a worn or damaged impeller unit.
• Assemble the pump in the reverse order.
– Tightening torque for all loosened screws: 3 Nm.
EN
AMX0053
33