Simple Troubleshooting - Thermador TCM24PS Guía De Usuario

Ocultar thumbs Ver también para TCM24PS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

en

Simple troubleshooting

Simple troubleshooting
The following table provides solutions for problems that may arise as you use your
Thermador machine. If you do not find a solution for your specific problem or the problem
persists after troubleshooting, please contact 1-800-944-2904.
Problem
Strongly fluctuating coffee
or milk froth quality (e�g�
fluctuation in quantity or milk
froth spraying)�
Drinks cannot be dispensed. Beverage outlet or one of the
The drink runs out at
the entire outlet during
dispensing�
Too little milk froth, none at
all, or the milk system is not
taking in any milk�
The personally selected
volume is not reached�
Coffee dispensing slows to a
trickle or stops completely�
Hot water milky or tastes of
coffee.
Coffee has no "crema".
30
Cause
Build-up of limescale in the
appliance�
The suction pipe is blocked.
3 connections are blocked.
Lower part of the beverage
outlet is missing�
Build-up of limescale in the
appliance�
Beverage outlet or one of the
3 connections are blocked.
Milk not suitable for foaming. Do not use milk that has already
Beverage outlet or the milk
tubes are not correctly
assembled.
The suction pipe is blocked.
Coffee is ground too finely.
Preground coffee is too fine.
Heavy build-up of limescale in
the appliance�
The brewing unit is soiled.
Milk tube has not been
removed�
Milk or coffee residue in the
beverage outlet.
Unsuitable type of coffee.
The beans are no longer
fresh�
The grinding level is not
suitable for the beans.
Solution
Descale the appliance according
to the instructions, see the
section "Service programs".
Clean the suction pipe�
Clean the beverage outlet and
the connections�
Attach the lower part, see the
section "Cleaning the milk
system".
Descale the appliance according
to the instructions, see the
section "Service programs".
Clean the beverage outlet and
the connections�
been boiled. Use cold milk with a
fat content of at least 1�5%�
Moisten the individual parts and
put them together again�
Clean the suction pipe�
Adjust the grinding level to a
coarser setting� Use a coarser
ground coffee.
Descale the appliance according
to the instructions, see the
section "Service programs".
Clean brewing unit, see chapter
"Cleaning the brewing unit".
Remove the milk tube from the
milk container�
Clean the beverage outlet.
Use a type of coffee with a higher
proportion of robusta beans.
Use fresh beans.
Adjust the grinding unit to a finer
setting�

Publicidad

Tabla de contenido
loading

Tabla de contenido