FTE Maximal ATLAS 64 Manual De Instalación Rápida página 26

6.1.4. Management Port
Using this menu is possible update the IP configuration, the password of the Web interface
and a remote access.
• Management Port
Hostname: Allow change the hostname of the device
by default is start. Remember to connect again must be
type http://new_value_of_ hostname.
IP Settings: Change the IP settings. If Obtain IP
address from DHCP is not checked it is necessary set
the value of the IP Address, Subnet mask and the
Default gateway.
Press the button Apply to update the new settings.
• Web Interface:
Use this option to change the password. Type the
current and the new password and press Apply to
update the change. The current session will be close
and you must be login with the new password to
continue.
• Dynamic DNS.
This option is designed to permit remote connection with the
device when we have a dynamic IP address from our service
provider.
6.1.5. Firmware upgrade
Use this option to upgrade the firmware of the device. Select the file in the option Upload
firmware pressing the button Select file. A dialog appear and must be choose the file .upg with
the new firmware. Press Upgrade to start the upgrade procedure. Show the screen a follow the
instructions to do the upgrade. Please, don't turn off the device while it is upgrading to avoid
damage.
6.1.6. Configuration
Choose in the list Active Configuration the type of the output modulation between DVB-T and
DVB-C. Press the button Apply to confirm. The device will be rebooting and the devices settings
will be cleared.
All right of technical changes and mistakes are reserved.
Quick installation Guide ATLAS 64
7
- -
ATLAS 64 Version en_1.1 Fte maximal