Installation Procedure For Windows 2000; Installing The Microsoft Driver - Belkin F5U219ea Manual Del Usuario

P73941ea-B_F5U219uk 14-03-2003 10:57 Page 9

Installation Procedure for Windows 2000

This procedure will install two USB 1.1 OHCI controllers and one USB 2.0
EHCI host controller.
Important Note: There are two methods of installing the required USB 2.0
1. If you have an Internet connection:
Windows 2000 will check the Windows update website and download
the most recent version of Microsoft USB 2.0 support drivers. Please
proceed to the "Installing the Microsoft Driver" section.
2. If you do not have an Internet connection:
USB 2.0 drivers will be installed from the Belkin Driver Installation
CD. Please proceed to the "Installing the Belkin Driver" section.

Installing the Microsoft Driver

1. Make sure your computer is completely powered down.
2. Remove the computer's cover and locate an empty PCI slot.
3. Remove the port cover that corresponds with the PCI slot you wish to
use. (The cover is usually held in place with a single screw.)
4. Insert the PCI Card into the slot. Apply pressure as needed until the
Card is fully seated. Secure the PCI Card with the screw removed in
step 3.
5. After installing the PCI Card, replace the outer cover and turn on the
computer.
Note: Do not plug any devices into the PCI Card until driver installation is
completely finished.
Note: Depending on the speed of your computer, it may take up to 30-60
seconds for the PCI Card to be detected.
INSTALLATION
drivers in Windows 2000.
9
En