Connecting To The Power Supply; Testing The Washer - LG WT7060C Serie Manual De Instrucciones

Ocultar thumbs Ver también para WT7060C Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

14 INSTALLATION
Connecting to the Power
Supply
The washer should be plugged into a 120-VAC, 60
Hz grounded 3-prong outlet. Plug in the washer.
WARNING
Do not use a worn or damaged power cord or
power plug. Replace or repair it immediately.
Failure to do so may result in death, fire, electric
shock, or malfunction.
Do not modify the power cord and plug
provided with the appliance. Do not damage
it when installing or moving the washer. Doing
so may result in death, fire, electric shock, or
malfunction.
Make sure that the washer is grounded.
Connect this washer to a grounded outlet
conforming to the rating prior to use. Failure
to do so may result in fire, electric shock, or
malfunction.
Do not damage or cut off the ground prong of
the power cord. Doing so may cause death, fire,
electric shock, or product malfunction.
Improper connection of the equipment-grounding
conductor can result in risk of electric shock.
Check with a qualified electrician or service
technician if you are in doubt as to whether the
appliance is properly grounded. If it does not fit
the outlet, have a proper outlet installed by a
qualified electrician.
The appliance and outlet must be positioned so
that the plug is easily accessible.
Do not use adapters or extension cords. Doing
so may result in serious injury, fire, electric
shock, or death.
For best performance, plug the washer into
its own individual outlet. This helps prevent
overloading house wiring circuits which could
cause a fire hazard from overheated wires.
If necessary, use a new, UL-listed 3-prong
adapter or 3-wire extension cord with a 3-prong
(grounding) plug rated at no less than the branch
circuit. Do not use an extension cord longer
than 3 feet. Failure to follow these warnings may
result in serious injury, fire, electric shock, or
death.

Testing the Washer

Check if the washer is properly installed and run a
test cycle.
1
Make sure the tub is empty. Do not load anything
in the tub for this test.
2
Press the Power button then immediately press
and hold both the Spin and Soil buttons until an
code appears in the display. (See below for
a key to the codes.)
Display
Initial test
Previous test result was good.
Previous test was ended with an
error.
NOTE
is displayed first, and
The indication is different for each model.
3
Press the Start/Pause button.
The washer will start the test, which will last about
3 minutes. The test automatically checks the
water inlet hoses and the drain hose.
4
Check the display for results.
If error code is displayed, refer to the following
guide.
Error Code
Fully open the water faucets.
Straighten out any kinks in the inlet
hoses and make sure the hoses are
not pinned against the wall or under
the washer.
Straighten out any kinks in the drain
hose and make sure the hose is not
pinned against the wall or under the
washer. Remove and flush out the
drain hose to remove clogs. Adjust
or repair the drain. Maximum drain
height is 96 inches.
5
End of cycle.
At the end of the test cycle,
display. The test cycle will end and the washer will
shut off automatically after a short delay.
Information
,
or
is displayed.
Solution
or
will

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido