Dell E04J Serie Manual De Instrucciones página 11

LED Indicators (continued)
EMM
Power supply/cooling fan
Switch
System identification button
Mode switch
Power Supplies
AC power supply (per power supply)
Wattage
Voltage
Heat dissipation
Maximum inrush current
Available Hard Drive Power (Per Slot)
Supported hard drive power
consumption (continuous)
EMM Power (Per Slot)
Maximum power consumed by EMM 14 W at +12 V
Maximum available power
Maximum available power
Three two-color LED status indicators,
one each for the two EMM SAS ports and
one for the EMM status
Three LED status indicators for power supply
status, power supply/cooling fan fault status,
and AC status
Located on the front control panel.
This button is used to locate a system
within a rack.
Located on the front control panel.
This switch is used to switch the system
between unified and split mode operation.
600 W
100–240 VAC (8.6 A–4.3 A)
188 W
Under typical line conditions and over the
entire system ambient operating range,
the inrush current may reach 55 A per
power supply for 10 ms or less.
Up to 1.2 A at +5 V
Up to 0.5 A at +12 V
100 W at +12 V
1 W at +5 V (standby)
Getting Started With Your System
9