Initialising The Sensor - SOMFY Sunis Indoor Wirefree RTS Guia De Instalacion

Initialising the sensor

A) Set the RTS motor/radio receiver to programming mode.
• Press the programming button on the remote control or radio
receiver for approximately 2 seconds:
the shutter/blind will briefl y move up and down.
• Briefl y press (0.5 seconds) the sensor programming button (1).
the shutter/blind will briefl y move up and down.
the sensor is ready for use.
Caution: If the sensor needs to be programmed with several
RTS motors or radio receivers, repeat steps A and B
for each radio motor or each RTS radio receiver.
> 2 seconds
Fig. 1
Page 10
Copyright © 2008 Somfy SAS. All rights reserved.
Fig. 1
Fig. 2
1
0.5 seconds
Fig. 2