The Installation Of The Outdoor Unit; The Initial Check; Installation - Hisense 12К Manual De Instrucciones

.
4 The Installation of Outdoor Unit

4.1 The Initial Check

● The outdoor should be kept in well ventilated and dry place.
● Make sure that the noise and exhaust do not disturb your neighbors .
● Never install the outdoor unit at the place with high oil fog, acidic, alkaline, salt mist or harmful gas
such as sulfur steam.
● Far away from radiation source at least 3 meters.
● Install snow hood before the inlet and outlet of the outdoor unit , when the machine is installed at
the ice area.
● Install the machine in shade place to avoid the sunshine directly and the high temperature heat
radiation.
● Not install the machine at the place with dustiness or pollution avoid the heat exchanger blocked.
● Not install the machine at the place easy to touch.
● Not install the machine at the place where the monsoon or the wind between building can blow the
fan directly.
NOTE: The fan could be destroyed by the strong wind when it blow the exchanger part of the outdoor
unit directly .
Be careful of the Aluminum foil fin, it is sharp.
There is no one allowed to touch the outdoor unit except the service engineer.

4.2 Installation

(1) Use the washer provided in the accessory to fasten the machine at the foundation bolts.
(2) When fasten the outdoor unit with the foundation bolts, the fasten holes position as the Fig4.2.
(3) Fasten the outdoor unit as the Fig4.3.
(4) Make sure fasten the outdoor unit tight and horizontal avoid to make noise when the machine oblique
Or inclined by strong breeze or earthquake.
(5) Not drain off water to the public places avoid to slip.
(6) Make a strong base( made of concrete or alike). The appliance should be placed not less than 10 cm high to
avoid being wet or corroded. Otherwise, it may cause damage to the appliance or reduce its life time.
(Figure 4.4)
Installation and Maintenance
Over 200mm
Fig.4.1
18