Refrigerant Piping; The Connection Of The Piping - Hisense 12К Manual De Instrucciones

5.Refrigerant Piping

Use refrigerant R410A in the refrigerant cycle(refer to outdoor nameplate). Do not
charge oxygen, acetylene or other flammable and poisonous gases into the refrigerant cycle
when performing a leakage test or an air-tight test. These types of gases are extremely
dangerous and can cause an explosion. It is recommended that compressed air, nitrogen or
refrigerant be used for these types of tests.
5.1 The Piping Materials
(1) Prepare locally-supplied copper pipes.
(2) Select the piping size from the following table.
36/42K/48K/60K
(3) Select clean copper pipes. Make sure there is no dust and moisture inside. Blow the inside
of the pipes with nitrogen or dry air, to remove any dust or foreign materials before connecting
pipes.
5.2 The Piping Connection
(1) Position of piping connection is shown in Fig.5.1.(Indoor Unit)
Drain pipe connector
Gas pipe connector
Liquid pipe connector
Check water pump here
(2) When tightening the flare nut, use two spanners as shown in Fig.5.2.
Gas pipe（mm） Liquid pipe（mm）
12K ø9.52
18K ø12.7
24K ø15.88
ø19.05
Hole for cords and cables
12K,18K
5
5
ø6.35
ø6.35
ø9.52
ø9.52
(mm)
6.35 20
φ12.7
6
20
Installation and Maintenance
24K,36K,42K,48K,60K