Carton Contents - Craftsman 358.773110 Manual Del Operador

CARTON CONTENTS
Check carton contents against the fol-
lowinglist,
Model 358,773110
Edger
Screws
Locknuts
Cable clamp
Hex wrench
2-cycle engine oil
Extra blade
Examine parts for damage. Do not
use damaged parts.
NOTE: If you need assistance or find
parts missing or damaged, call
1-800-235-5878.
ASSEMBLY
.'I,_
_IbWARNING: If received as-
sembled, repeat all steps to ensure
your unit is properly assembled and all
fasteners are secure.
This operators manual has been de-
veloped to help you assemble the unit
and to provide its safe operation. It is
important that you read the entire
manual to become familiar with the
unit before you begin assembly.
Read your operators manual,
Tools you will need:
• Adjustable wrench
• Hex wrench (provided)
TUBE ASSEMBLY
NOTE: When performing the follow-
ing steps, be sure the handle is
aligned as follows: label on top,
throttle trigger to the operator's right
hand side. The starter rope and the
throttle cable must not wrap around
the tube.
1. Assemble handle tube to the lower
tube (it will be necessary to pull
some of the starter rope out of the
housing).
2. Align the screw holes; insert the
screws through the aligned holes.
3. Thread one iocknut onto each
screw and tighten securely.
Handle tube
Screws
\
Lower
Tube
Stader Rope
Locknuts
NOTE: When performing the follow_
ing step, be sure the starter rope is not
caught under the cable clamp. The
starter rope must hang freely to oper_
ate properly.
4. Align the cable clamp between the
tube screws. Install the cable
clamp around the tube and throttle
cable.
Cable Clamp
Throttle cable
5