Using The Menus. Main Menu; Input Configuration - Televes Avant 5 Manual De Instrucciones

User instructions
Using the menus - Main Menu
1.- INPUT CONFIGURATION menu
The first menu that appears is "UHF Config" menu:
- Scrolls through the options of the menu.
- (short press) -Places the cursor on each modifiable parameter.
- (long press) - Enters the extended menu.
- (short press) - Changes to the next menu: Filters configuration.
- (long press) - Saving and adjustment.
Procedure
First of all, press the
the desired configuration for the UHF1-UHF2-UHF3 inputs: 9-0-1, 7-2-1, 6-3-1.
UHF Config
U1: 9 - OFF
U2: 0 - OFF
U3: 1 - OFF
Then press the button to enter the following option of the menu -Inputs powering-. You will be able to select the
input powering mode for each input: Auto, OFF, ON.
ON: Input powering activated.
OFF: Input powering deactivated.
Auto: If there is an amplifier connected and the input signal level is not enough, the Avant will power the amplifier
automatically.
UHF Config
U1: 9 - OFF
U2: 0 - OFF
U3: 1 - OFF
Press to activate and modify the powering through the other two inputs.
Press to enter the next menu.
Note:
- In this menu, if the current configuration of the inputs is 9-0-1, the user will not be allowed to modify the
default value (OFF) for the input powering through U2.
button to activate (blinks) the first option -Distribution of inputs-. Use
UHF Config
U1: 9 - OFF
U2: 0 - OFF
U3: 1 - OFF
UHF Config
U1: 9 - OFF
U2: 0 - OFF
U3: 1 - OFF
UHF Config
U1: 7 - OFF
U2: 2 - OFF
U3: 1 - OFF
UHF Config
U1: 9 - Auto
U2: 0 - OFF
U3: 1 - OFF
39 39
"Avant 5"
buttons to select
UHF Config
U1: 6 - OFF
U2: 3 - OFF
U3: 1 - OFF
UHF Config
U1: 9 - ON
U2: 0 - OFF
U3: 1 - OFF