Preparing For Use; Baby Unit; Corded Operation; Battery Operation (Non-Rechargeable Batteries) - Philips AVENT SCD600 Manual De Usario

EngliSh
10
important
Read this user manual carefully before you use the appliance and save it for future reference.
- Never immerse any part of the baby monitor in water or any other liquid.
- Check if the voltage indicated on the adapters of the baby unit and the parent unit corresponds
to the local voltage before you connect the appliance.
- Only use the adapters supplied to connect the baby unit and the parent unit to the electrical
outlet.
- The power outlet should be located near the appliance and easily accessible.
- The adapters contain a transformer. Do not cut off the adapters to replace them with other
plugs, as this causes a hazardous situation.
- If the adapters are damaged, always have them replaced with one of the original type in order
to avoid a hazard. For the correct type, see chapter 'Replacement'.
- Never use the baby monitor in moist places or close to water.
- Children should be supervised to ensure that they do not play with the appliance.
- Use and store the appliance at a temperature between 50°F (10°C) and 95°F (35°C).
- Do not expose the baby unit and parent unit to extreme cold or heat or to direct sunlight. Do
not put the baby unit and the parent unit close to a heating source.
- Make sure the baby unit and the cord are always out of reach of the baby (at least 1 metre/3
feet away).
- Never place the baby unit inside or mount it on the baby's bed or playpen.
- Never cover the parent unit and the baby unit with anything (e.g. a towel or blanket).
- The operating range of the baby monitor is 150 metres/490 feet in open air. Depending on the
surroundings and other disturbing factors, this range may be smaller.
- If you have any combination of cordless phones, wireless video, Wi-Fi networks, microwave or
Bluetooth on 2.4Ghz, connection problems may occur. The connection between the parent unit
and the baby unit could be lost for some seconds or may cause interference with other devices.
- We advise you to use the parent unit corded to save energy. The baby video monitor consumes
more energy than a standard baby monitor (without video).
- This baby monitor is intended as an aid. It is not a substitute for responsible and proper adult
supervision and should not be used as such.
- This monitor is not intended to be used as a medical monitor and its use should not replace
adult supervision.

preparing for use

Baby unit

You can use the baby unit corded or on non-rechargeable batteries. Even if you are going to use the
unit corded, we advise you to insert non-rechargeable batteries. This guarantees automatic back-up
in case of power failure.

Corded operation

1 Put the appliance plug in the baby unit and put the adapter in a wall outlet (Fig. 4).

Battery operation (non-rechargeable batteries)

The baby unit runs on four 1.5V R6 AAA batteries (not included). We recommend you use Philips
R06 PowerLife batteries or an equivalent type.
Do not use rechargeable batteries, as the baby unit does not have a charging function.
Unplug the baby unit and make sure your hands and the unit are dry when you insert non-
rechargeable batteries.
1 Remove the screw in the battery compartment lid with a flathead screwdriver (Fig. 5).
2 Remove the battery compartment lid. (Fig. 6)