Philips AVENT SCD600 Manual De Usario página 18

EngliSh
18
Question
Why does the video
display flicker?
Why isn't there any
image on the video
display when the power-
on light is on?
Why isn't the image on
the video display clear?
Why doesn't the parent
unit work in the
automatic screen
activation mode?
Why isn't the image on
the video display clear
in night vision?
Why doesn't the battery
symbol appear on the
video display of the
parent unit when I start
to charge the parent
unit?
Why doesn't the parent
unit charge when I have
plugged it in?
Answer
Interference may occur when the parent unit is out of range of the
baby unit. Interference may also occur if there are too many walls or
ceilings between the parent unit and the baby unit or when other
2.4GHz wireless devices are switched on (e.g. microwave, internet).
Put the parent unit in a different place, closer to the baby unit, or
switch off other wireless devices.
The rechargeable battery of the parent unit may need to be charged.
The parent unit may be in the automatic screen activation mode.
Press the automatic screen activation button again to switch on the
video display.
The display brightness may be set too low. Increase the display
brightness (see chapter 'Features').
The distance between the baby and the baby unit may be too large.
Make sure that the baby unit is placed 1 to 1.5 metres/3 to 5
feet away from the baby.
The distance between the baby and the baby unit may be too large.
Make sure that the baby unit is placed 1 to 1.5 metres/3 to 5
feet away from the baby.
It may take a few minutes before the battery symbol appears on the
video display of the parent unit when you charge the parent for the
first time or after a long period of non-use.
The rechargeable battery may have reached the end of its life.
Replace the rechargeable battery.