Adjusting Display Brightness; Automatic Screen Activation; Lullaby Function - Philips AVENT SCD600 Manual De Usario

Features
adjusting loudspeaker volume
You can adjust the loudspeaker volume of the parent unit to the level you prefer.
1 Turn the volume wheel up or down to adjust the volume. (Fig. 16)
Note: If the volume is set to a high level, the parent unit consumes more power.

adjusting display brightness

You can adjust the display brightness of the parent unit to the level you prefer.
1 Press the brightness adjustment buttons on the parent unit to adjust the brightness of the
video display. (Fig. 24)
Note: If the brightness is set to a high level, the parent unit consumes more power.
Sound level lights
The parent unit continuously monitors the sound level in your baby's room and the sound level
lights let you know if there is any activity. If your baby cries, the green sound level lights light up on
the parent unit.
- As long as the baby unit does not detect a sound, all sound level lights on the parent unit are
out.
- When the baby unit picks up a sound, one or more sound level lights on the parent unit go on.
The number of lights that go on is related to the loudness of the sound picked up by the baby
unit. The sound level lights also go on when the parent unit is set to a low volume or when the
automatic screen activation mode is activated (see section 'Automatic screen activation'
below) (Fig. 25).

automatic screen activation

The parent unit continuously monitors the sound level in your baby´s room. When the automatic
screen activation mode is activated, the video display only switches on when the baby unit picks up
a sound. As long as no sound is detected, the video display is off to save power.
1 To activate the automatic screen activation mode, press the automatic screen activation
button on the parent unit. (Fig. 26)
The automatic screen activation light on the parent unit goes on (Fig. 27).
,
When the baby unit detects a sound, the video display on the parent unit automatically goes
,
on to show the baby. When no sound is detected for 30 seconds, the video display goes out
again.
2 To switch off the automatic screen activation mode, press the automatic screen activation
button on the parent unit again.
nightlights
1 Press the nightlight button on the baby unit to switch on the nightlights. (Fig. 28)
The nightlights on the baby unit go on. (Fig. 29)
,
2 Press the nightlight button again to switch off the nightlights.
Tip: Switch off the nightlights when you operate the baby unit on non-rechargeable batteries. This saves
power.

lullaby function

Note: When the baby unit plays a lullaby, it consumes more power.
1 Press the play/stop button to start the lullaby (Fig. 30).
EngliSh
13