Kitchen Aid 36 Manual Del Usuario página 3

Built-in opening
requirements Q
dimensions
All dimensions *l/8" (3 mm) -
Injury Hazard
Special care should be taken at
all times to prevent refrigerator
from tipping, as it is top heavy.
A solid soffit or two, 2" x 4" x 32"
(5cmxlOcmx81cm)wood
boards to cover the width of the
compressor cover are required
above the refrigerator to prevent
tipping during use.
If solid soffit is more than 1 inch
(2.5 cm) above refrigerator, two
2" x 4" x 32" (5 cm x 10 cm x
81 cm) wood boards must be
installed on the wall l/4 inch
(6 mm) above the refrigerator
cover. The bottom surface of the
boards should be 84 inches
(213 cm) from floor. Boards must
be long enough to fully cover
width of compressor cover.
Failure to follow these
instructions could result in
injury.
The built-in refrigerator can be
installed:
l
recessed in the cabinet opening.
l
at the end of cabinets using a side
panel to enclose the refrigerator side.
Select one method and use dimensions
given. Dimensions shown provide 0" (0
cm) clearance.
\
i 1 Mark stud
II
I I locations on
II
I I rear wall
II
; ! 80" - 90"
II
I I (203-229 cm) I I
" above floor. "
Grounded electrical
outlet location
Grounded electrical
outlet is required.
0
7
/
/
/
I
Install side panel
(optional) support
board on rear wall if
opening depth is 25"
(64 cm) or more.
(19zl)
-Width
b
Water line location
Water line
must
provide 15-l 00 psi
l-l/2"
(103-690 kPa)
I k-4
(3.8 cm)
(1 87im)
water pressure.
c
Rough in water
line before
installing
refrigerator.
(12.5 cm)
l/2" (12 mm)
hole for plumbing
can be located
anywhere within
- shaded area.
-Floor:
Must support refrigerator,
contents, and door panels.
Opening dimensions
r
Model 36" (91 cm) 42" (106 cm) 48" (122 cm)
Width min.
35-l/2" (90 cm) 41-l /2" (105 cm) 47-l /2" (120 cm)
Height min. 83-l /4" (211.5 cm)
83-l /4" (211.5 cm) 83-l /4" (211.5 cm)
Height max. 84-3/4" (215
cm) 84-3/4" (215
cm)
84-3/4" (215
cm)
Depth min. 23-l /2" (60
cm) 23-l /2" (60 cm) 23-l /2" (60 cm)
Page 3