Kitchen Aid 36 Manual Del Usuario página 8

Parts supplied for installation:
l
base grille
l
miscellaneous parts bag
Check that all parts were included.
To prevent damage to product or
floor covering:
l
Do Not lower the refrigerator
against the shipping base when
removing the shipping base.
l
Do Not remove protective film
until refrigerator is in operating
position.
l
All four leveling legs must
contact the floor to support and
stabilize the full weight of the
refrigerator.
l
Keep cardboard shipping piece
or plywood under refrigerator
until it is installed in operating
position.
1 Remove and save literature
. package and parts bag taped to
5 Place top of cardboard
ld
. carton or plywood under
refrigerator door. Remove four
refrigerator. Remove dolly. Open
brackets (two on each side) attaching
appliance doors and remove all boxes,
shipping base to refrigerator bottom.
parts packages and packing materials
Do Not remove tape and door
from refrigerator and freezer
bracing until product is secured in
compartments. Do Not remove
final location. See Page 3.
protective film.
Move the refrigerator straight back and
evenly into the opening. Check that:
l
copper tubing is not kinked.
l
power supply cord is on top of
L. Place
appliance dolly
under
refrigerator
side and
loosely
wrap dolly
-C--.-
refrigerator.
3 Place sections of shipping carton
. on the floor when rolling dolly
and refrigerator into the house. Move
refrigerator close to built-in opening.
Injury Hazard
Because of the weight and size of
the refrigerator, two or more
people are required to install it.
Most of the refrigerator's weight is
at the top. Extra care is needed
when moving the refrigerator to
prevent tipping.
Failure to follow these instructions
could result in injury.
4
Set'power
at top of cabinet
to "OFF" position.
Plug power supply
cord into
grounded outlet.
Install retainer on
grounded outlet using
screw from parts bag.
refrigerator next to cover.
compression
union
L 1
compression
nut nut
l/4"
(6
mm)
sleeve
Slide a compression nut and sleeve on
open end of each copper line. Use a
copper tubing union to connect both
copper lines.
Do Not over-tighten.
Turn water supply valve to "OPEN"
position. Turn refrigerator switch
"ON." Wait a few minutes. Check
water line connection and water valve
on top of cabinet for leaks. Without
kinking the tubing, carefully place it
back underneath cabinet.
Insert carton corner posts between
strap and refrigerator at side trim
Check that water supply line has
pieces and handles. Carefully tighten
been flushed. See Page 7.
strap making sure side trim and
6 Pull copper line from refrigerator
handles are protected.
. water valve and copper line from
plumbing forward from underneath
Page 8
refrigerator. Remove cap from water line.