Winner M532-34 Manual De Empleo página 35

Receiver Introduction
Front & Back Panel
10. Power LED︰Shows On/Off status of the 2.4GHz RF transmission function.
11. IR Sensor︰Receiving IR signal from the remote controller.
12. Source Key︰
Ⅰ → Press this key around 3 sec to turn on/off the 2.4GHz RF transmission function
Ⅱ → When the included power adaptor is connected, press this button to switch
between input sources on TV1.
Ⅲ → When the 2.4GHz LED is lighting, hold this key for 3~5 seconds to shut down
the 2.4GHz RF transmission.
13. UHF Antenna
14. 2.4GHz Integrated Antenna
15. 2.4 GHz (video) Channel Switch
There are 4 channels available for selection. When interference in video quality
occurs, you can switch to the other channels for the best video quality possible.
Note︰It is necessary for the receiver and transmitter to be on the same channel
to receive video signals.
16. TV2 Output Port︰
This allows simultaneous COMPOSITE signal output.