Install Handles; Install Base Grille - JENN-AIR JS42NXFXDW Manual De Instalación

Complete Installation
1. Use the installation block to measure the gaps between the
overlay panels and adjacent cabinets.
Stainless steel panels require a ³⁄₈" (0.95 cm) gap between
the stainless panel and the cabinets and a ¹⁄₈" (0.32 cm)
gap between the freezer and refrigerator door, and the
doors and top grille.
A
B
A. Adjacent cabinet
B. Installation block
C. Overlay panel on door
2. Adjust the panel to achieve the required spacing, or to align.
IMPORTANT: If adjustments are needed, adjust the panel not
the door.
Slide the overlay panel from side to side in the keyhole
slot.
Use an Allen wrench to raise or lower the adjustment pins
which allows the door panel to swivel.
C
A. Door panel
B. Mounting bracket
3. Predrill a ¹⁄₈" deep pilot hole the door panel through the open
holes in both the bottom and top hinges.
4. Using slotted hex head screws (provided), attach the top and
bottom hinges to the door panels. Fully tighten all door panel
screws.
A
A. Top hinge
B. Mounting bracket
C
C. Adjustment pins
B
C D
C. Holes for screws
D. Adjustment pins
5. Using slotted hex head screws (provided) for each side, attach
the door panels to the hinge-side door trims.
6. Using Phillips head flat screws (provided), install the handle
side door trim.
7. Completely tighten the screws attaching the mounting
brackets, located at the bottom of the doors, to the overlay
panels.
8. Reinstall the top door trim and hinge cover.
9. Snap the adjustment pin cover (provided) into place.
IMPORTANT: Install the handles after the door panels have been
installed.
Tools Needed: ³⁄₃₂" Allen wrench
1. Locate the holes in the door panels where the handle
mounting studs are to be installed.
2. Fasten the handle mounting studs to the door panels.
3. Install the handles to the handle mounting studs and tighten
the setscrews.
NOTE: Depending on the handle, the setscrews may be either
a separate part, or a component of the mounting stud.
There are two pieces to the base grille to allow for a custom fit: the
base grille itself and the skirt. The skirt can be added to the base
grille in order to extend it all the way to the floor.
1. To see whether the skirt is needed, place the base grille into
position. Do not attach the base grille to the refrigerator.
Measure the distance between the bottom of the base grille
and the floor. The gap must be a minimum of ¹⁄₂" (1.27 cm) in
order to add the skirt.
NOTE: If the gap measures less than ¹⁄₂" (1.27 cm), skip
steps 3 and 4 of the instructions, and install the base grille
only.
A
2. Remove the film from the base grille.
3. Snap the skirt onto the base grille.
B

Install Handles

(Panel Kit Models Only)

Install Base Grille

A
B
A. Base grille
B. Skirt
19