Powers Fasteners TRAK-IT TOOL C3 Manual Del Operador página 12

much as you would squeeze a tube of toothpaste. This squeezing action ensures that all of
the Fuel will be used, and that the Trak-It tool can operate in any position.
Because of this container-within-a-container design, you might hear the sound of fluid
when shaking the Fuel Cell after all the Fuel has been used. This is the propellant that
remains between the containers.
If you expose the empty Fuel Cell to extreme temperatures, the propellant gas will
expand and could cause the container to burst, releasing flammable gases.
METERING VALVE
The Metering Valve contains the Fuel Metering System that ensures that the correct
amount of fuel is injected into the combustion chamber. The BLUE Metering Valve is
the only valve that will operate properly with the Trak-It tool.
ATTACHING THE METERING VALVE TO THE
FUEL CELL
To attach the Metering Valve to the Fuel Cell, you begin by taking off the Protective
Shipping Cap, and removing the Metering Valve from inside the cap. Next, place the
Metering Valve on top of the Fuel Cell with the stem pointing forward and away from
your face and eyes. Engage the front lip of the Valve and then push down firmly on the
rear of the Valve. You should hear it click as it snaps into place.
1. Push to release value
4. Push front
ridge first
TRAK-IT TOOL MODEL C3, C3 ST
2. Separate value from cap
5. Push down back
ridge 1st click
12
3. Align ridges square
6. Push down flush
2nd click
12